This holds the part in place until you separate it later. These are holding tabs – places where you prevent the tool from cutting all the way through. You will also see some small gaps in the yellow paths. These tool paths are shown in yellow above. The second operation was a helical hole in the end holes of the stator and center hole of the rotor plates. The first was a profile cut along the outside of the plate perimeters. In my case, there were two types of operations. Then you apply the tool using a specific operation to the contours of the drawing. You also indicate the speed the tool will rotate, how fast you want to feed the tool across the surface to be cut, how deep you want each pass to cut, and so on. In my case, this is a 1/8” diameter end mill. With Estlcam, you set up the tool that you want to use. As shown above, Estlcam can be used to create the tool paths, simulate their performance, and then prepare the G-Code for the CNC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |